Microsoft TS: Upgrading MCSA on Windows serv 2003 to Windows Serv 2008 Sample Questions:

1. Your network contains an Active Directory domain named contoso.com. An Administrator named Admin1 plans to install the Routing and Remote Access service (RRAS) role service on a server named Server1. Admin1 is not member of the Domain Admins group.
You need to ensure that Server1 can authenticate users from Active Directory by using Windows authentication.
What should you do?

A) Install the Network Policy Server (NPS) role service on a domain controller.
B) Install the Active Directory Lightweight Directory Services (AD LDS) role on Server1.
C) Add the computer account to the RAS and IAS Servers group.
D) Add the computer account for Server1 to the Windows Authorization Access Group.

2. Your network contains two DHCP servers named Server1 and Server2. On Server1, you create a scope named Scope1.
You need to ensure that DHCP clients receive IP addresses from the address range in Scope1 if Server1 is unavailable.
The solution must prevent both servers from assigning duplicate IP addresses.
What should you do from the DHCP console?

A) On Server2, create a scope, and then enable Network Access Protection.
B) On Server1, select Scope1, and then run the Split-Scope wizard.
C) On Server1, create a superscope.
D) On Server2, create a scope, and then reconcile each scope.

3. Your network contains an Active Directory forest named contoso.com. Contoso.com contains three domain controllers that run Windows Server 2008 R2 and three domain controllers that run Windows Server 2003. All domain controllers are configured as DNS servers.
You configure the contoso.com zone to use DNSSEC.
You need to ensure that the zone only replicates to DNS servers that support DNSSEC.
What should you do first?

A) Move the contoso.com zone to the ForestDnsZones application directory partition.
B) Create an application directory partition.
C) Add a server certificate to the Windows Server 2003 DNS servers.
D) Modify the Notify settings of the contoso.com zone.

4. Your network uses IPv4. You install a server that runs Windows Server 2008 R2 at a branch office. The server is configured with two network interfaces.
You need to configure routing on the server at the branch office.
Which two actions should you perform? (Each correct answer presents part of the solution. Choose two.)

A) Run the netsh interface ipv4 enable command.
B) Install the Routing and Remote Access Services role service.
C) Run the netsh ras ip set access ALL command.
D) Enable the IPv4 Router Routing and Remote Access option.

5. You need to document the following configurations of a server that runs Windows Server 2008 R2:
-System services
-Startup programs
-Hardware configuration
-Current CPU, network, disk, and memory utilization
Which command should you run?

A) systeminfo.exe
B) perfmon.exe /report
C) mrinfo.exe localhost
D) msinfo32.exe

Solutions: