Avaya Ethernet Routing Switch Implementation Sample Questions:

1. Ethernet Routing Switch (ERS) 5500 portfolio shares a number of common hardware features.
Which feature is unique to the ERS 5530 and is not available on the other ERS 5500 switches?

A) User Interface push button
B) Universal Serial Bus (USB) port
C) Console serial port
D) Network management Ethernet port

2. The goal of the Converged Campus architecture is to provide a highly reliable infrastructure with sub second failover preventing any interruption of traffic on the network.
HMD primary benefits of this design goal? (Choose two)

A) The ability to provide hitless software upgrades for the core of the network.
B) in the event of a failure, no loss of connectivity or application availability will be experienced by the end user
C) This design goal provides numerous connectivity options including Asynchronous Transfer Mode (ATM), Packet over SONET (POS) and 10 gigabit Ethernet.
D) The architecture provides high performance Layer 3 switching, resiliency, security, and services.

3. Avaya recommends using RSMLT edge in place of VRRP with Backup Master, when available what are two valid reasons for using RSMLT edge? (Chouse two)

A) RSMLT edge allows the cluster to be configured to discard untagged frames in 1ST and SMLT ports.
B) RSML T dynamically balances the CPU load across the switch cluster.
C) the VRRP hold down timer cannot be set high enough to update the complete routing table when Layer 2 access requirements are high.
D) RSMLT edge provides support for application where more than 255 redundant default gateways (VRRP limit) need to be provided.
E) RSMLT edge is easier to configure and lightens the CPU load,

4. In Ethernet Routing Switch (ERS) 5600 switch was added into the existing ERS 5500 stack, but ft did not form a proper stack.
Which statement describes the problem?

A) The ERS 5600 was set as the Base Unit.
B) The mode parameter on the ERS 5600 switch was set to Mixed Mode.
C) The ERS 5500 was set as the Base Unit.
D) The stack was reset for a change in Base Unit to take effect.

5. A customer needs to install a new Ethernet Routing Switch (ERS) 2550T on the 172.16.5.0/24 network, but does not have a console cable available.
Which statement is correct?

A) The switch will first attempt to use BootP to acquire an IP address, and if that fails it will assign IP address 192.160.1.1/24 to the switch IP.
B) To communicate with an ERS 2550T the IP address must first be set though the console interface.
C) The customer can connect to the network management Ethernet port which is pre-configured to use the 192 168 1 1/24 IP address
D) The customer can set the switch to use the temporary address of 192.168.192.168 by pressing the User Interface button on the front of the ERS 2550T

Solutions: